Workshop Technology MCQs

1.Identify the incorrect statement from the options below:

A mortise gauge is equipped with a pair of marking pins.Gouges are chisels featuring a concave blade design.An auger is classified as a tool used for planing.All of the above statements are false.None of the above.

2.What is the process called that involves smoothing out a bent sheet metal to make it flat?

3.Why is it essential to perform tandem drawing on wires and tubes in multiple stages?

Because dimensional precision cannot be achieved in a single stepSince the surface texture gets better with each drawing passBecause a large reduction cannot be accomplished all at onceBecause annealing must be done between drawing phasesTo increase the strength without any intermediate process

4.What is the standard shrinkage allowance for a cast iron pattern?

5.What is the minimum recommended distance between two spot welds in spot welding?

6.What does the process of lancing involve?

Partially cutting a metal sheet along its length and then folding the cut sectionShaping metal by removing material from the edge of a plateMaking a straight cut along the length of a metal sheetBending a metal sheet around a curved line

7.At what temperature range is cold working of metals typically performed?

Below the recrystallization temperatureExactly at the recrystallization temperatureAt any given temperatureAbove the recrystallization temperature

8.What is required to produce a neutral flame?

A higher amount of acetylene compared to oxygenEqual amounts of acetylene and oxygenA greater amount of oxygen than acetyleneNone of these options

Workshop Technology MCQs

About this subject